View source for VoIP FAQS Configure SIP account with and without TLS certificate

= With TLS Certificate =

== Yealink ==
<gallery heights="500px" widths="500px">
File:Tls yealink0.PNG|Caption1
File:Tls yealink1.PNG|Caption2
File:Tls yealink2.PNG|Caption3
</gallery>


== JITSI ==
<gallery heights="500px" widths="500px">
File:Jitsi TLS Cert 000.png|Caption1
File:Jitsi TLS Cert 001.png|Caption2
File:Jitsi TLS Cert 002.png|Caption3
File:Jitsi TLS Cert 003.png|Caption4
File:Jitsi TLS Cert 004.png|Caption5
</gallery>

== ZOIPER ==
<gallery heights="500px" widths="500px">
File:ZOIPER 001.png|Caption1
File:ZOIPER 002.png|Caption2
File:ZOIPER 003.png|Caption3
File:ZOIPER 004.png|Caption4
</gallery>

== CSIP SIMPLE ==


# Install csipsimple;
# Open csipsimple and add an account using the "wizard" inside of "Generic wizards", "Basic";
# Fill Account name, user, server and password and then Save;
# Press continuously on the account until it appears a sub-menu, then choose "Choose wizard", followed by "Generic wizards", "Expert";
# Click on the account and modify the option "Transport" for TLS. Save configurations. At this time, the account may not work yet, so it's necessary to proceed with the following steps:
## Back to the initial menu, click on the options button (mobile phone) and choose "Settings";
## Click on the options button and choose "Expert Mode";
## Click on Network and, after that, on Secure protocol;
## Enable TLS transport;
## Modify TLS Method for TLSv1;
## Modify TLS CA file with the location of CA file;
## Modify TLS certificate file with the location of "file";
## Modify private key file with the location of file;
## Go back to the initial menu.


= Without TLS Certificate =

== BRIA softphone for IOS ==


* Install BRIA softphone (available in Apple Store);
* Open BRIA and add a SIP account with a remote IP Phone;
<gallery heights="600px" widths="600px">
File:BRIA1.png
</gallery>
* In ''Account Status'', fill the following fields (according to the previously configured credentials on IPBrick): account name, display as, username, password and domain;
<gallery heights="600px" widths="600px">
File:BRIA2.png
</gallery>
* On the bottom of the page go to ''Account Advanced'' and select:
** Define ''Outbound Proxy'' and ''Authorization Name'';
** Change ''SIP transport'' to TLS.
<gallery heights="600px" widths="600px">
File:BRIA3.png
</gallery>
* Save;
* On your left menu, go to ''Advanced Settings'' and verify if TLS Cert is disabled.
<gallery heights="600px" widths="600px">
File:BRIA5.png
</gallery>
* Go back to Accounts, select the "information" icon and ''Enable'' the Account.